Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- SKF 2314/C3 Self Aligning Ball Bearings
- Single Row Ball Bearing
- 0.0
- SKF 2316/C3 Self Aligning Ball Bearings
- Self Aligning Ball Bearings
- 0.0
- SKF 2205 E-2RS1TN9/C3 Self Aligning Ball Bearings
- Pillow Block
- 0.0
- 75 mm x 160 mm x 55 mm SKF 2315 K Self Aligning Ball Bearings
- Cam Followers Stud Type
- 0.0
- 95 mm x 170 mm x 43 mm SKF 2219 M Self Aligning Ball Bearings
- Pillow Block
- 0.0
- 50 mm x 90 mm x 58 mm SKF 11210 TN9 Self Aligning Ball Bearings
- Sleeve Bearings
- 22.0
- SKF 1203 Self Aligning Ball Bearings
- Bearings
- 0.0
- SKF 2318 M/C3 Self Aligning Ball Bearings
- Bearings
- 0.0