Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- FAG 11307-TVH Self Aligning Ball Bearings
- Bearings
- 0.0
- FAG 11305-TVH Self Aligning Ball Bearings
- Bearings
- 0.0
- FAG 1326-K-M Self Aligning Ball Bearings
- Bearings
- 0.0
- FAG 1324-K-M Self Aligning Ball Bearings
- Spherical Plain Bearings - Rod Ends
- 0.0
- FAG 1322-M-C3 Self Aligning Ball Bearings
- Bearings
- 0.0
- FAG 1321-M-C3 Self Aligning Ball Bearings
- Cam Followers Stud Type
- 52.0
- FAG 1320-K-J Self Aligning Ball Bearings
- Tapered Roller Bearings
- 0.0
- FAG 1321-K-M Self Aligning Ball Bearings
- Needle Non Thrust Roller Bearing
- 0.0
- FAG 1320-J Self Aligning Ball Bearings
- Angular Contact Ball Bearing
- 0.0
- FAG 1319 Self Aligning Ball Bearings
- Angular Contact Ball Bearing
- 0.0
- FAG 1315-M-C2 Self Aligning Ball Bearings
- Thrust Ball Bearings
- 0.0
- FAG 1313-K-TVH Self Aligning Ball Bearings
- Pillow Block
- 0.0